Materiais necessários

Pedra plana e lisa (tamanho da palma da mão)
Tinta acrílica cinza
Tinta acrílica preta
Tinta acrílica branca
Tinta acrílica azul
Tinta acrílica vermelha
Pincel chato médio
Pincel fino para detalhes
Spray selante transparente
Lápis

Guia passo a passo

1

Passo 1: Paint the metallic robot body

Wash and dry your angular rock. Paint the entire surface with metallic silver paint. While still slightly wet, shade the edges and corners with darker gray to create a dimensional metal plate appearance. The rock should look like brushed steel or aluminum plating.

2

Passo 2: Add the robot face panel

Paint a rectangular panel in the upper portion of the rock for the robot face. Use slightly darker gray for this panel to define it from the body. Add two circular or rectangular eye lights in bright blue or cyan — these are the robot's sensors and visual indicators. Make them glow by adding white dots inside.

3

Passo 3: Add technical details and panels

Paint a series of smaller rectangular panels, ventilation grills, and technical markings on the lower body. Use thin black lines to create a panel-like grid pattern. Add small indicator lights — mix of red and blue dots — to suggest a control panel or status displays. Add gold or yellow circuit-line details.

4

Passo 4: Paint the robot mouth and antenna

Paint a rectangular mouth grille with vertical black lines for a speaker effect. Add small silver bolts or screws at the corners of the face panel. Paint a thin antenna rising from the top of the robot head with a small blinking red light at the tip.

5

Passo 5: Add reflective highlights and seal

Using white paint and a fine brush, add bright highlight lines along the upper and left edges of each panel to simulate light reflecting off a polished metal surface. These highlights give the robot a three-dimensional, real metal appearance. Apply clear sealant.

Passo 6: Adicionar código RoxGeo

Escreva ROXGEO.COM seguido de uma barra e o código único da sua pedra (ex. ROXGEO.COM/ABC123) na parte inferior ou verso.

Dicas úteis

Escolhe uma pedra cujo formato se adeque ao teu tema.
Esboça o design a lápis antes de começar a pintar.
Deixe cada camada secar completamente antes de adicionar a seguinte.
Sele com spray transparente para proteger a pedra no exterior.
Para o código no verso, use marcador permanente à prova d'água. Aplique 2-3 camadas de verniz.
#ROXCODE (ex. #ROXABC123) na pedra facilita a busca no Google.
O endereço completo ROXGEO.COM/CODE leva o descobridor diretamente ao mapa da pedra.

Pinte esta pedra e rastreie sua viagem com RoxGeo!

Baixar RoxGeo grátis